ahnsa.blogg.se

Safe to put 10 lb mainspring in ruger sp101
Safe to put 10 lb mainspring in ruger sp101






  1. Safe to put 10 lb mainspring in ruger sp101 manual#
  2. Safe to put 10 lb mainspring in ruger sp101 plus#
  3. Safe to put 10 lb mainspring in ruger sp101 series#

I found out the hard way because somehow I pulled it. All internal parts were polished and and. A 12 lb spring is recommended, however a 10 lb spring can be used with. I installed the 10 mainspring and 10 trigger spring for a noticeable improvement. Follow all the precautions they say about not pulling the trigger when it's apart. To remove the mainspring, place the rounded end of the hammer strut in a padded. Note: Factory trigger return spring is 10 pounds, factory hammer spring is 14 pounds. Go to Brownells or Midway and order a spring kit, while you have it apart you might as well swap the springs for a better trigger pull.

Safe to put 10 lb mainspring in ruger sp101 manual#

All easy stuff with the owners manual in front of you.

Safe to put 10 lb mainspring in ruger sp101 series#

This pak contains 1 each 9, 10, and 12 pound reduced power hammer springs for Ruger SP-101 series revolvers and 1 each 8 pound trigger return spring allowing adjustment for lighter and smoother trigger and hammer action. I just want to see how far I can make consistent hits on a 10' steel target with it using my hand loade. Ruger are simple all you need is a screwdriver to get the grips off and a paperclip or small finish nail to break dowd the mainspring. 357 Magnum, and 9×19mm Parabellum ), six-shot (. The SP101 is a small frame and all-steel-construction carry revolver, with a five-shot (. They say if you go with the lightest hammer spring you should replace the trigger spring with the one in the kit. 22lr, 8 shots, 4 15 inch barrel The Ruger SP101 is a series of double-action revolvers produced by the American company Sturm, Ruger & Co. It comes with four springs, three different weight hammer springs, and one trigger spring.

Safe to put 10 lb mainspring in ruger sp101 plus#

It was 10 bucks plus the shipping, so around 14 dollars.

safe to put 10 lb mainspring in ruger sp101

Looking at carrying the Buffalo Bore 180gr 357mag outdoorsman. Was looking at 10mm, then 40 and 45, but I dont like the limited availability of 10mm, and the less than ideal power of 40 and 45 against things with 4 legs. It’s solid, a handful, but not too heavy, weighing in at 1 pound, 9.1 ounces on my scale. Looking into getting a Ruger SP101 2.25' barrel for carrying out in the woods. I know it is by no means a target gun but it couldn't hurt so I ordered the SP-101 spring kit from Wolff Gun Springs at . The SP101 is a small frame revolver but it doesn’t feel like you’re missing anything when you pick it up. I find that the 14-pound pull or thereabouts on my Ruger was a bit much and affected accuracy so I wanted to lighten it up.








Safe to put 10 lb mainspring in ruger sp101